Rki-instruments 35-3000RK-LEL/O Instrukcja Użytkownika Pobierz pdf (Strona 11)

35-3000RK-LEL/O Sample-Draw Detector • 7

Installation

This section describes procedures to mount the sample-draw detector in the monitoring

environment and wire the sample-draw detector to a controller.

Mounting the Sample-Draw Detector

1. Select the mounting site. Consider the following when you select the mounting site.

• Is there enough room to open the housing door and make wiring connections at

the bottom of the housing and tubing connections at the right of the housing?

• Make sure there is sufficient room to perform start-up, maintenance, and

calibration procedures.

• Are the flowmeter and status lights visible?

Figure 3: Mounting the Sample-Draw Detector

4. Close and latch the housing door.

NOTE: The sample-draw detector is shipped with the mounting feet “tucked under” the

housing to protect the mounting feet during shipment.

6.5 in.

4.0 in.

Note: The housing is 4.25 in. deep.

8.5

in.

9.3

in.

8.9

in.

3/4 in. conduit hub

(total of 2 hubs)

7.3 in.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Brak uwag

Rki-instruments 35-3000RK-LEL/O Instrukcja Użytkownika Strona 11